This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
welcome [2024/02/23 15:38] 192.168.1.23 [Converting from German to International] |
welcome [2024/02/27 20:02] (current) 192.168.1.23 [Converting from German to International firmware] |
||
---|---|---|---|
Line 3531: | Line 3531: | ||
user adam2 adam2 | user adam2 adam2 | ||
you may now enter the following command and very quickly power on your Fritz box | you may now enter the following command and very quickly power on your Fritz box | ||
- | quote GETENV | + | quote GETENV |
| | ||
if the result is: | if the result is: | ||
Line 3540: | Line 3540: | ||
you can even power off and then power on again your device and without disconnecting your linux lftp, issue the | you can even power off and then power on again your device and without disconnecting your linux lftp, issue the | ||
- | quote GETENV | + | quote GETENV |
in-order to confirm that your Fritz returns the international ID | in-order to confirm that your Fritz returns the international ID | ||
firmware_version avme | firmware_version avme | ||
you may now use the [[https:// | you may now use the [[https:// | ||
- | the above steps, successfully converted my two German Fritz 3370 to the international version. this same procedure may or may not work on your similar but nox exact Fritz box | + | the above steps, successfully converted my two German Fritz 3370 to the international version. this same procedure may or may not work on your similar but not exact Fritz box |
Good Luck | Good Luck | ||
+ | ==== Flashing openwrt ==== | ||
+ | you need [[https:// | ||
+ | |||
+ | remove power from your fritz box and issue the following command (use the appropriate initramfs-kernel for your box): | ||
+ | eva_ramboot.py 192.168.178.1 openwrt-22.03.6-lantiq-xrx200-avm_fritz3370-rev2-micron-initramfs-kernel.bin | ||
+ | power on your fritz box, wait a few minutes and you should be able to log in 192.168.1.1 | ||
+ | |||
+ | you can now download the proper sysupgrade image and finalize your install |