This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
welcome [2024/02/23 15:11] 192.168.1.23 [FRITZ!Box WLAN 3370] |
welcome [2024/02/23 15:38] 192.168.1.23 [Converting from German to International] |
||
---|---|---|---|
Line 3506: | Line 3506: | ||
====== FRITZ!Box WLAN 3370 ====== | ====== FRITZ!Box WLAN 3370 ====== | ||
- | ==== Converting from German to International ==== | + | ==== Converting from German to International |
- | you will need a linux box & a windows, preferably win7 box (side by side) | + | you will need a linux box & a windows, preferably |
- | it' | + | if you are familiar with windows & ftp and are able to find an ftp client with similar features to the lftp under linux, you may well skip the linux box |
+ | |||
+ | searching the netland about this, I bumped on the [[https:// | ||
+ | |||
+ | my advice is to go with a linux/lftp box or even use the [[https:// | ||
+ | |||
+ | it' | ||
if you have flashed your Fritz with an alternative firmware, you will need to get back to your official firmware using the [[https:// | if you have flashed your Fritz with an alternative firmware, you will need to get back to your official firmware using the [[https:// | ||
Line 3517: | Line 3523: | ||
get lftp if not already installed and issue the following: | get lftp if not already installed and issue the following: | ||
- | |||
lftp | lftp | ||
set net:timeout 1; | set net:timeout 1; | ||
Line 3525: | Line 3530: | ||
open 192.168.178.1 | open 192.168.178.1 | ||
user adam2 adam2 | user adam2 adam2 | ||
+ | you may now enter the following command and very quickly power on your Fritz box | ||
+ | quote GETENV firmware version | ||
+ | | ||
+ | if the result is: | ||
+ | firmware_version avm | ||
+ | that means, your Fritz box is the German version and you may switch it to the intentional one by issuing the following command: | ||
+ | quote SETENV firmware_version avme | ||
+ | that's it ! you have now switched your German Fritz box to an International Fritz box | ||
+ | |||
+ | you can even power off and then power on again your device and without disconnecting your linux lftp, issue the | ||
+ | quote GETENV firmware version | ||
+ | in-order to confirm that your Fritz returns the international ID | ||
+ | firmware_version avme | ||
+ | you may now use the [[https:// | ||
+ | |||
+ | the above steps, successfully converted my two German Fritz 3370 to the international version. this same procedure may or may not work on your similar but nox exact Fritz box | ||
- | quote GETENV firmware version | + | Good Luck |