This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
welcome [2017/10/13 19:49] alex [firmware tftp] |
welcome [2020/12/14 16:39] alex [rb711 serial pins] |
||
---|---|---|---|
Line 2923: | Line 2923: | ||
2). After the above procedure, it's recommended to first start the tftp on the server before starting the tftp transfer procedure at the bullet-m. | 2). After the above procedure, it's recommended to first start the tftp on the server before starting the tftp transfer procedure at the bullet-m. | ||
+ | |||
+ | ===Further annoying issues as of October 2017== | ||
+ | |||
+ | 1). to avoid any networking locking issues it's better to connect the device on a fast 100Mbit switch. | ||
+ | |||
+ | 2). start the tftp (I use atftp) | ||
+ | |||
+ | 3). cold reboot the Bullet-M | ||
+ | |||
+ | 4). either hold the reset for 10 seconds and then release it or start the urescue from the U-boot menu on the serial console. | ||
====== bullet 5 Openwrt ====== | ====== bullet 5 Openwrt ====== | ||
Line 3280: | Line 3290: | ||
opkg install quagga-bgpd | opkg install quagga-bgpd | ||
| | ||
- | ====== rb711 flash howto ====== | + | ====== rb711 serial pins ====== |
+ | {{http:// | ||
+ | |||
+ | ====== rb711 flash howto ====== | ||
Connect ethernet to the RouterBoard device | Connect ethernet to the RouterBoard device | ||