This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
welcome [2017/06/01 16:16] alex [Firmware upgrade] |
welcome [2017/10/13 19:57] alex [firmware tftp] |
||
---|---|---|---|
Line 2923: | Line 2923: | ||
2). After the above procedure, it's recommended to first start the tftp on the server before starting the tftp transfer procedure at the bullet-m. | 2). After the above procedure, it's recommended to first start the tftp on the server before starting the tftp transfer procedure at the bullet-m. | ||
+ | |||
+ | ===Further annoying issues as of October 2017== | ||
+ | |||
+ | 1). to avoid any networking locking issues it's better to connect the device on a fast 100Mbit switch. | ||
+ | |||
+ | 2). start the tftp (I use atftp) | ||
+ | |||
+ | 3). cold reboot the Bullet-M | ||
+ | |||
+ | 4). either hold the reset for 10 seconds and then release it or start the urescue from the U-boot menu on the serial console. | ||
====== bullet 5 Openwrt ====== | ====== bullet 5 Openwrt ====== | ||
Line 3238: | Line 3248: | ||
* setup dnsmasq on a linux system (liveCD or liveUSB is fine too, check [[http:// | * setup dnsmasq on a linux system (liveCD or liveUSB is fine too, check [[http:// | ||
* select from bootloader to boot from ethernet | * select from bootloader to boot from ethernet | ||
+ | |||
+ | Update (2017): Lede firmware moved from yaffs2 to ubi file-system. | ||
+ | |||
+ | * netboot the device, use [[http:// | ||
+ | * after net_booting wget or scp [[http:// | ||
+ | * finally issue: sysupgrade / | ||
+ | |||
+ | Older instructions: | ||
+ | |||
* netboot the device, use [[http:// | * netboot the device, use [[http:// | ||
* follow the next steps: | * follow the next steps: |