This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
welcome [2017/06/01 16:13] alex [OpenWrt Power] |
welcome [2017/10/13 19:57] alex [firmware tftp] |
||
---|---|---|---|
Line 2021: | Line 2021: | ||
mtd write -r openwrt-adm5120-wp54g-wrt-jffs2.trx mtd1 <-- new format | mtd write -r openwrt-adm5120-wp54g-wrt-jffs2.trx mtd1 <-- new format | ||
</ | </ | ||
+ | < | ||
+ | update 06/2017 | ||
+ | root@LEDE:/ | ||
+ | dev: size | ||
+ | mtd0: 00050000 00010000 " | ||
+ | mtd1: 003a0000 00010000 " | ||
+ | mtd2: 00010000 00010000 " | ||
+ | mtd3: 00001048 00001048 " | ||
+ | mtd4: 000e479c 00010000 " | ||
+ | mtd5: 002ba800 00010000 " | ||
+ | mtd6: 001e0000 00010000 " | ||
+ | mtd7: 001e0000 00010000 " | ||
+ | |||
+ | root@LEDE:/ | ||
+ | Unlocking trx ... | ||
+ | |||
+ | Writing from lede-adm5120-router_le-wp54g-wrt-squashfs.trx to trx ... | ||
+ | Rebooting ... | ||
+ | </ | ||
======Avila gateworks====== | ======Avila gateworks====== | ||
Line 2904: | Line 2923: | ||
2). After the above procedure, it's recommended to first start the tftp on the server before starting the tftp transfer procedure at the bullet-m. | 2). After the above procedure, it's recommended to first start the tftp on the server before starting the tftp transfer procedure at the bullet-m. | ||
+ | |||
+ | ===Further annoying issues as of October 2017== | ||
+ | |||
+ | 1). to avoid any networking locking issues it's better to connect the device on a fast 100Mbit switch. | ||
+ | |||
+ | 2). start the tftp (I use atftp) | ||
+ | |||
+ | 3). cold reboot the Bullet-M | ||
+ | |||
+ | 4). either hold the reset for 10 seconds and then release it or start the urescue from the U-boot menu on the serial console. | ||
====== bullet 5 Openwrt ====== | ====== bullet 5 Openwrt ====== | ||
Line 3219: | Line 3248: | ||
* setup dnsmasq on a linux system (liveCD or liveUSB is fine too, check [[http:// | * setup dnsmasq on a linux system (liveCD or liveUSB is fine too, check [[http:// | ||
* select from bootloader to boot from ethernet | * select from bootloader to boot from ethernet | ||
+ | |||
+ | Update (2017): Lede firmware moved from yaffs2 to ubi file-system. | ||
+ | |||
+ | * netboot the device, use [[http:// | ||
+ | * after net_booting wget or scp [[http:// | ||
+ | * finally issue: sysupgrade / | ||
+ | |||
+ | Older instructions: | ||
+ | |||
* netboot the device, use [[http:// | * netboot the device, use [[http:// | ||
* follow the next steps: | * follow the next steps: |